How To Program Comcast Remote To Dynex Tv
3 related questions. More How To Program Comcast Remote To Dynex Tv videos.
Find the 5 digit codes that correspond with the brand of your TV, DVD, or other device in the list below. You may want to write them on a scrap of paper. Read the following steps before performing them. Press the cable button at the top of the remote.
How To Program Comcast Remote
This will clear any button pushes from memory. If you mess up on any of the following steps, press the exit button followed by the cable button and start back at step 3.
Press either the TV or AUX button (whichever one you are planning to program) once. It will blink red if you press it correctly. Press and hold the setup button until the TV or AUX button flashes twice. Enter the first 5 digit code you wrote down into the keypad. If you completed this correctly, the TV or AUX key will blink twice. If it does not, Go back to #2 above on this page. 6. Now, test your remote by pressing the TV or AUX button (whichever one you programmed), and aiming it at your device.
Then press the power button. If your device turns on and off as you press power on the remote, then you have successfully completed programming and should skip to step 5. If the remote does not operate the device, go back to #2 above on this page. OR of you have tried all the codes or you want to do this faster go to the next step. Read the following steps before performing them. Be sure to press the cable button to clear the remote.
If you mess up any steps, press the exit button followed by the cable button and go back to #2. Turn on your TV or other device by pressing its power button.
On your remote, press the TV or AUX button (the one you want to program) once. Press and hold the setup button until the TV or AUX button blinks twice 4. Type 991 into the keypad, NOT 911. Then press either 0 for another cable box, 1 for a TV, 2 for a DVD, VCR, or PVR, or 3 for any audio device. Press the power button and then aim the remote at your device. Press the channel up button until the device turns off. Stop pressing immediately when the device turns off.
Press the setup button to lock in the IR code. The TV or AUX button will blink twice. Check that you did this correctly by turning your device on and off with the remote. If it works, continue. If it does not, go back to #2. I have a Sanyo DVD player along with an Xfinity/Comcast DVR. One tried the Sanyo codes that came in the programming pamphlet from Comcast and none of them worked.
Hope it helps yours. The reason for this Logon balancing error 88 is, that the datatype of the registry value HKLM System CurrentControlSet Services TCPIP Parameters DatabasePath is changed from REG_EXPAND_SZ to REG_SZ. I resolved mine Friday by doing the following: Start the registry editor and rename the registry value HKLM System CurrentControlSet Services TCPIP Parameters DatabasePath (change it to DatabasePath1 or something similar so you don't lose it) Create an EXPANDABLE-String Value (REG_EXPAND_SZ) with the same name and value. 
Seriously, check to see if you have MSN Messenger 7.0 or 7.5 installed. (should be -%SystemRoot% system32 drivers etc) That worked for my situation.
I tried the codes on this site and they didn't work either. As a matter of fact i tried codes from multiple website and not a single code worked.
Comcast Remote Codes
I've programmed the remote for different TV's, other DVD players and even VHS VCR's and have never had any of then not work with atleast one of the codes. I'm at a loss now and am stuck as to what to do now.
Program Charter Remote
Any suggestions?